Flight plan doesn't cover area in top down

Did you see a mistake? Have you experienced an issue? Please tell us, so we can fix it.
Post Reply
RobCleaver
Posts: 1
Joined: Mon Dec 02, 2019 10:26 pm

Flight plan doesn't cover area in top down

Post by RobCleaver » Tue Dec 03, 2019 8:28 am

When the flight plan was created it didn't cover all of the are.

Image

I've planned similarly large and hilly flights without this issue happening. Any ideas as to the cause or cure?

EDIT: I've set the take-off point lower down the hill and the flight plan covers the whole area. 110m elevation change from top to botom. Do you know what causes this?

Image

Cheers
Attachments
Screenshot_2019-11-27_152131.jpg
Original take off point.
Screenshot_2019-11-27_152131.jpg (243.35 KiB) Viewed 2538 times
Screenshot_2019-12-03_081752.jpg
Lower take off point.
Screenshot_2019-12-03_081752.jpg (248.38 KiB) Viewed 2538 times

gil_dh
Posts: 12
Joined: Tue Apr 10, 2018 3:26 pm

Re: Flight plan doesn't cover area in top down

Post by gil_dh » Fri Jan 10, 2020 10:15 am

Hello,

The reason for the incomplete coverage when liftoff is not the lowest point in the terrain is that we currently do not support negative altitudes. Since 0 altitude is the point where drone liftoffs and we cannot go below 0 altitude in waypoints (actually 1 meters is the lowest allowed value at the moment) - you get incomplete coverage in the lower parts of the terrain.

Example to explain:

* Say you have a terrain with elevation difference of 200 meters from lowest to highest points in the terrain.
* You set liftoff from a point that is 100 meters above the lowest point in the terrain.
* You fly 50 meters AGL.
-> this means that there will be points that will not be covered since some points will be at relative -50 meters AGL (and some at -40, -30 etc).

So to summarize: you should consider the relative difference in altitudes and the altitude of planned flight when selecting liftoff point. It does not have to be the lowest point, but the relative altitude of this point minus the flight altitude should be above 0.

We have plans for this year to support negative altitudes, then this problem will go away.

Regards
DH Team

Post Reply

Return to “Bug Reports”